4. Fix the flue (top section) bracket (see figure 1c below) into the correct position on the wall using the
supplied self-tapping (nylon type) fixing screw sets.
5. Fix the unit body mounting bracket onto the wall to the exact position using the three supplied ‘wall mate’
type self-drilling (metal type) screws sets (consisting of 1 x screw-in socket and 1 x 30mm flathead screw
per set). For instructions on how to install the ‘wall mate’ screw sets, contact the manufacturer. The
supplied ‘wall mate’ self-drilling screw sets are suitable for plasterboard walls with supporting timber stud
or noggin. Where specialised fixing bolts / screws are required for tiled, concrete or masonry walls, these
must be obtained separately.
6. Prior to mounting the canopy rangehood onto the wall, first slot both sections of the flue cover onto the unit
body with the flue cover top section fully retracted inside the bottom section flue cover. Do not extend or
pull the top section out. The top section must be fully (lmportant: Leave the protective film on both flue
covers to prevent from scratching during installation).
7. Fix the bottom section flue cover onto the rear of the unit body using the four supplied screws.
8. Mount the unit onto the mounting bracket by hooking the hanging slots at the rear of the unit onto the
hooks of the mounting bracket. (See Figure 2a & 2b)
Figure 1a
Figure 1b
Figure 1c
Figure 2a
Figure 2b
9. The installer must ensure that the rangehood is securely fixed onto the wall. Any additional fixings in
addition to the above may also be added to further secure the rangehood against the wall. This is
dependent on wall type, rangehood type, fixing type and any other circumstance which may affect its
stability. Usually this can be achieved by screwing the back plate against the wall using suitable fixings (not
supplied). Optional rubber stops are also supplied for fixing to the bottom corners at the rear side of the
rangehood. This may be fixed (using the supplied screws) to enable the back of the rangehood to be level
with the wall should additional fixings be employed.
10. Euromaid accepts no responsibility for any damage caused by the installer’s negligence to properly mount
and secure the rangehood.
11. Connect the flue duct pipe to the unit.
12. To assemble the flue cover (2 x standard length sections):
12.1. For model EUC90SS, EUC90GS & EUC60GS (See Figure 3a & 3c)
Slide the top section flue cover from inside the bottom section cover to extend upwards to the
required location. Fix the top section flue cover onto the mounting bracket using the two
supplied screws (figure 3c, screws ‘D’) at the top of the top flue cover.
12.2. For model EUC91SS (See Figure 3b)
Connect cover B onto the top of hood body A. and fix cover B with screws C
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales